HDZero AIO5 F4 Flight Controller with HDZero VTX and ELRS Receiver

Overview

The HDZero AIO5 is the world’s first digital video All-In-One (AIO) solution, bringing digital FPV to the next level. Designed to enable ultra-light 65mm whoops to weigh less than 19.4g, the HDZero AIO5 integrates a powerful F4 flight controller, a 5.8GHz digital video transmitter (VTX), an SPI ExpressLRS 3.0 receiver, a 4-in-1 DSHOT ESC, and a 5V/1A BEC all on a single board.

Advanced Design and Durability

With an improved minimum voltage of just 2.5V, the HDZero AIO5 ensures your video transmission stays active even when the motors stop functioning. Built with a single thick PCB, this design maximizes durability and simplifies the assembly process for your tiny whoop builds. Say goodbye to compromises and enjoy clear, uninterrupted digital video for your next flight!

Specifications

• MCU: STM32F411 (100MHz, 512K Flash)
• Gyro: BMI270
• Onboard voltage and amperage meters
• Built-in 5A(each) BLHeli_S 4-in-1 ESC
• ESC MCU: EFM8BB21
• HV Current: 5A continuous peak, 6A (3 seconds)
• Factory firmware: O_H_5_48_V0.19.2.HEX
• DSHOT600 ready
• Built-in 5.8G HDZero VTX
• RF Output: 25mw/200mW
• Supported channels: R1-R8, F2/F4, L1-L8
• U.FL connector (with included ultra-lite linear antenna)
• Built-in SPI ExpressLRS 2.4GHz receiver
• Packet rate options: 25Hz/50Hz/150Hz/250Hz/500Hz
• Pre-soldered enamel wire antenna
• Telemetry output power: <12dBm
• Built-in 5V 1A BEC
• Flight controller firmware target: CRAZYBEEF4SX1280
• Power supply: 1S battery (2.5V – 4.35V)
• Compatible with popular whoop frames
• Board size: 28.5mm x 28.5mm with a 25.5mm x 25.5mm mounting hole
• Weight: 5.7g (without motor plugs), 6.3g (with motor plugs)

What's Included

• 1x HDZero AIO5 board
• 1x Power cable with inverted angle A30 connector
• 4x Screws
• 4x Rubber grommets
• 1x Ultra-lite linear VTX antenna