iFlight SucceX-D F7 TwinG V2.1 HD Flight Controller

Item number: 19910

54,24 €

including 16% VAT., plus shipping

Available now! (Shipping time: 1 - 2 workdays)

The SucceX-D F7 V2.1 is designed to work seamlessly with DJI’s new HD FPV system. To make things even simpler, the DJI Air unit can just be plugged into the FC with the included wire harness. In addition, we added the popular and reliable USB Type-C instead of Micro USB and therefore the same standard than your DJI module.


• Universal USB Type C connector instead of micro USB

• Plug-and-Play. No need to solder tiny wires.)

• Supports BLHeli pass-through for easy ESC upgrade and configuration.

• Designed to support DJI Digital FPV

The TwinG uses two identical gyros oriented side by side with one offset 90 degrees from the other. Betaflight uses GYRO FUSION to blend and average the information from both gyros to send a much cleaner signal to the PID loop controller! Less noise and fewer oscillations across the throttle band without adding any delay! Betaflight software filters can be lowered in most cases as well, which brings a significant decrease in delay.

With plenty of processing power and uarts, this is the perfect flight controller for long-range GPS builds. And the TwinG configuration makes it the perfect Fc for builds like macro quads, cinematic filming rigs and x-class racers that are a bit trickier to tune.

TwinG Gyro Setup
-The Betaflight target's default setting is ‘gyro_to_use = both’ / Gyro fusion is active!
-To check the current setting, please use CLI and type ‘get gyro’ to find the responding entry.
-Change the settings with ‘set gyro_to_use = ’ and type ‘save’.
-To get the most reliable performance or encounter noise, oscillation and bent props: Please use the default setting ‘both”.
-For Single Gyro use, please use the debugging options to find and tune for the cleaner gyro, but lose the dynamic fusion and averaging.
-BF offers the following dual gyro debug options: dual_gyro_raw, dual_gyro, dual_gyro_diff, dual_gyro_combined.
-BlackboxLog explorer graph: dual_gyro_raw Debugging = [0] Roll Gyro1, [1] Pitch Gyro1, [2] Roll Gyro2, [3] Pitch Gyro2.
-The displayed graph will show the Gyro_Raw reading (no filters applied), both gyros can be compared.

FC Specifications
- MCU:216MHz STM32F722RET6
- Gyro: 2x ICM20689(SPI)
- Baro:NO
- OSD:AT7456E
- Blackbox: Onboard, 32MB
- 5x Uarts
- 8x Motor outputs
- 8-pin 4in1 ESC port
- 4-pin VTX connector

FC Firmware
- Betaflight
- Target:EXF722DUAL

- Mounting hole:30.5*30.5mm,f4mm with Grommets f3mm

Package included:
- SucceX F7 TwinG V2.1 Flight Controller(Dual ICM20689)
- 4x silicon grommets M4 to M3
- 1x 8pin 4in1 ESC harness
- 1x 4pin vtx harness

DJI FPV Air Unit Compatible:

 2  Ratings

Share your experience with other customers: