Each QAV-R FPV racing quad kit comes complete with 4 arms sized to support either 4", 5", or 6" propellers. The corresponding frame sizes are listed below, measured diagonally from motor shaft to motor shaft. 4" Prop Arm = 180mm
5" Prop Arm = 220mm
6" Prop Arm = 260mm
Full 3K Carbon Fiber airframe featuring a solid 2mm main plate and 4mm removable arms
Custom aluminum hardware to enable one tool, quick swapping of arms in race pit settings
Black Oxide steel screws
Easy grip anodized spacers
Lumenier Neoprene Landing Pads
Multiple motor mounting holes to fit a variety of motors (M3 and M2 screw mounting patterns).
"Bumpers" on the end of the arms to protect the motor during a crash, just like the QAV250.
Flight controller cover plate includes cutouts for SMA connector and video transmitter as well as a holder for the included XT-60 Lipo pig-tail.
Included Lumenier 4Power power distribution board and XT-60 Pig-Tail to power ESCs and FPV flight electronics. The PDB can optionally be outfitted with a Pololu 12v or 5v voltage step-down (Pololu board not included).
Easy Lipo Access (suggested Lipo is a 1300mah 3 or 4s)
Support for 32mm board cams as well as 26mm cams in cases such as the Lumenier CM-650.
Support to carry HD camera (such as the GoPro 4, Mobius, or GoPro Session) with optional camera vibration mount (not included)
Airframe: 109g (airframe + hardware), 116g (with PDB).
AUW: The QAV-R FPV Quadcopter is flown with an AUW of ~290g depending on motor choice (includes all flight electronics and FPV gear, but without Lipo or HD camera).
HD Vibration Mount
The QAV-R FPV Quadcopter does not exhibit any vibration in the on-board FPV camera signal. For pilots that wish to equip their airframe with a Mobius, GoPro or GoPro Session, Lumenier offers a vibration isolation camera mounting kit (sold separately).
1x QAV-R Carbon Fiber airframe
4x 4mm Carbon Fiber Arms
1x Board camera mount
1x 26mm camera mount
1x Set of black steel screws and aluminum hardware including knurled spacers
1x Lumenier 4Power Power distribution board + set of 6mm stand-offs
1x XT-60 Pig-Tail and silicone grommet
4x Neoprene Landing Pads
1x Lumenier lipo strap