KISS ESC 2-5S 25A/40A 4in1 32bit

Item number: 15100

99,90 €

including 19% VAT., plus shipping

Available now! (1 - 3 workdays)
Description

KISS ESC 2-5S 25A 4in1 (40A Limit) Dshot 2400

32bit brushless Motor Ctrl


The KISS ESC25A 4in1 is simply connected to the FC with a cable and can then be installed in the stack under or over the FC. All you have to do is solder the 4 x 3 motor cables and the voltage supply from the Lipo.
With a maximum short-term current output of up to 160A (4 x 40A), sufficient reserves of power are available for future motors.

As usual, the controller transmitsall important telemetry data such as voltage, current, temperature or speed via the TLM line. These can then be displayed via an OSD or in the remote control.

32-Bit-ARM Cortex M4 MCU @ 80 MHz
Telemetry capability (voltage, current, temperature, rpm)
Over current protection (measures the current and reduces it to max 40A)
Over temperature protection (reduces the max power if hotter then 100°C)
sinHybrid :: Sinwave/BackEMF Hybrid Commutation for smoother running.)

Dshot 2400 (Full resolution of 2000 steps takes only 6.5µs).
Supports all common Dshot commands like turtle mode, 3D mode and rotation direction change.

Expanded adaptive auto timing (7.5-30° advance on each commutation),
For Race Multicopters (25A continuous also with weak cooling),High max. RPM (500.000ERpm, 71.400Rpm with a 14Pole Motor)
Small size (37.5 x 42.5 mm) 3cm hole distance with 3,4mm size to stay full compatible
Accurate RPM control (2000 steps using Dshot)
No additional capacitor needed for 3-5S.
Very fast throttle response, Linear throttle response, Active freewheeling (low diode losses)
Regenerative braking

100-2400, Oneshot42, Oneshot125 and (25 - 500 Hz) PWM get autodetected.
Supports FrSky Sbus, Graupner SumD, TBS CROSSFIRE and Multiplex SRXL, S-Port, Graupner HOTT, TBS CROSSFIRE and Sensorbus
Operating voltage 6 - 24V (2-5s)
Maximum continuous current 25A, instantaneous maximum current 40A, actively limited
600000 ERPM maximum rotation field speed (useage up to 500000 recommended)

6 Layer 70µm copper PCB where almost all of the layers can be used for the current as the logic parts sits on a seperate PCB
All in and outputs are protected against over (~30V) and undervoltage(~-30V) but are still 3,3 and 5V compatible
Modern smart gate driver.
1980µF 25V ceramic capacitors onboard

Characteristics
ECS:
Ratings

 1  Rating

Share your experience with other customers: