The wait is over!
I would like to Introduce the Mr. Steele V4 SILK 2306 (2345KV) 4S FPV freestyle motor.
I take great pride in my work and am always trying to raise the bar. After two years of seemingly nonstop research & development, I am proud to present this fine piece of Miniquad motor engineering.
V4 MOTOR HIGHLIGHTS/CHANGES
base redesign 16x16(only) mounting holes (structural changes for more durability)
Complete bell redesigned (durability and smoothness in mind)
Thicker single strand copper winding
increased EFFICIENCY & POWER
Complete Interchangeable motor pants redesign (thicker & more crash/low temperature resistant, better gap fitment, + more protection coverage for the “tall pants”)
better assembly tolerances
Overall QC improvements
9mm steel bearings
Motor weight 31.8g
(full-length cables) compared to Stout V3 at 30.5g
Low - 1g vs (0.8 v3)
Tall - 2g vs (1.8 v3)
All in all this motor is an absolute gem only increasing the weight by a tad over 1g from the previous model while achieving more power, efficiency, and most importantly durability.
V3- V4 COMPATIBILITY
V4 and V3 motors are completely cross-compatible.
V3 bells - V4 stator
V4 bells - V3 stator
( everything is interchangeable except pants) The pants are stator-specific and can be interchangeable but with less than desired effect.
Enjoy & Thank you for your continued support.
Stator Size (Diameter): 23mm*6mm
Magnets: N52SH Curved
Windings: 15turn DLRK
Shaft Length (mm): 11.5mm
Shaft Diameter (mm): 4mm
Shaft material: Steel
Weight (With Wires) (g): 32.4g
Cells (Lipo): 4S
Max Current (A): 45A
Max Burst Current (A): 50A
Internal Resistance (Rm): 60mΩ
Wire Spec (AWG): 20#-135mm
Base Mounting Pattern: 16x16mm
Base Mounting Thread: M3 Thread
Motor Overall Dimensions: φ28.6mm*17.5mm
1 x Motor
1 x Tall Motor Pants
1 x Short Motor Pants
4 x motor screws