BetaflightF4 Flight Controller

Item number: 10620

49,90 €

including 19% VAT. , plus shipping

Not available now!

BetaflightF4 is the flight controller designed to use every possible feature of Betaflight.

BetaflightF4 is the follow up design to the very popular BetaflightF3. Following in the same path as Betaflight F3 we have kept a very similar footprint in terms of design with a few added modifications. The F405 has replaced the F303 to allow for lower CPU loads.

We have eliminated the 5v/3.3v jumper and added two seperate connection points, one for sbus and one for spektrum users. The jumper still remains for the battery voltage/5v connection for connecting your camera. While wiring the board it is recommended to get power for your vtx either from a different 5v source on the board or if using a higher voltage vtx power it from the battery input coming into the pdb. Running ground loop at Agnd with gnd wires from camera and vtx is still recommended to give the cleanest video signal.

Another small design change to this board was changing the BEC, this change takes the recommended 5v 2A current limit and drops it down to 5V 1.5A, its a small change but one that we opted for in order to use a more reliable BEC.

BetaflightF4 now comes with telemtry pads for BLHeli32 ESCs these pads are located between the signal and gnd pads for the ESC connections.


Integrated PDB
Built in OSD customizable via Betaflight OSD
Current sensor
Intuitive layout
Tailored to support Betaflight
When running 8K/8K, CPU usage remains low


F4 Processor
MPU6000 Gyro/ACC Sensor
3 x UART ports (one for radio receiver)
Built in 1,5A 5V BEC
Built in OSD ? configurable via Betaflight GUI
SD Card adapter for BlackBox
Current sensor
Power distribution board with six-layer PCB
Weights 8.6g

Average product review

4 Stars
3 Stars
2 Stars
1 Star

Share your experience with other customers:

Total entries: 3
5 from 5 Sehr gut!

Funktioniert einwandfrei. Hatte nur etwas Probleme beim Löten, auf manchen Pads hielt das Lötzinn nicht richtig und der Kontakt hat sich wieder gelöst. Musste bereits 2 Kabel nochmals löten. BF OSD und Current Sensor sind super!

., 29.05.2017
5 from 5 Freat F3 FC

Works great, runs 8k/8k, quality seems very good. the only downside is the soldering, especially the small ground pads can be a pain to solder.

., 25.07.2017
5 from 5 Clever FC

Simply it works.
For more, there are no tiny f****ing connectors, but soldering pads in clever layout.

., 03.01.2018
Total entries: 3